BECOME A PARTNER

Polishing Standards

Thermal Control.
Factory-Grade Luster.

The intrinsic surface finish of a Çimstone slab is achieved at the factory using advanced Breton™ calibration lines. Fabricators must only polish the cut edges. Proper thermal management during edge polishing is critical; dry sanding generates excessive heat, permanently damaging the quartz matrix and causing invisible micro-fissures that lead to delayed chipping.

Wet Polishing Thermal Control
01

Strict Processing Rules

  • Wet Polishing Only: All edge profiling and polishing must be performed using continuous clean water injection and wet diamond polishing pads. Absolutely no dry polishing is permitted.
  • RPM Limits: Machine speeds must never exceed 3,500 RPM. When utilizing 1000-grit pads or higher, speeds must be reduced further to prevent resin burn.
02

Chemical & Surface Bans

  • Chemical Ban: Do not apply aftermarket polishers, waxes, fillers, sealers, or gloss-enhancing chemicals to Çimstone surfaces.
  • Seam Polishing: Polishing should not be performed over seams afterward to preserve the factory calibration and finish.
03

Approved Pad Sequences

  • For Satin/Matte Finishes:
    100 ➔ 200 ➔ 400 grit.
  • For Polished/Gloss Finishes:
    50 ➔ 100 ➔ 200 ➔ 400 ➔ 500/800 ➔ 1500/2000 ➔ 2000/3000 grit ➔ Final Buff.

Distributor Portal

USERNAME / ID is required
PASSWORD is required